The fischer Nylon DuoTec lever for high tensile and transverse loads using 2 components. Simple mounting with a low hole diameter of 10 mm and a short pivot element also in narrow and isolated recesses. Simple pre-assembly, the plug does not sink into the hole even without a screw. No cuts and therefore weakening of the plasterboard panel. The tilting element automatically expands behind the plate and offers you its load capacity. Thanks to the flexible housing of the stainless steel screw, the dowel block can be used with wood screws and suspension plates or with locking and metric threaded rods with locknut. When matching holes in solid materials, it functions as an expansion plug.
Combination of two material components for higher performance.
Use of suspension plate screws, beffe brackets and metric-threaded screws.
The round sleeve reinforces the bore and allows significantly higher transverse loads.
The curved handle allows for palpation of obstacles before mounting.
Advantages:
The flexible screw housing allows the use of screws and brackets with different shapes of threads.
Plastics reinforced with fiberglass and the metal skeleton part (fischer DuoTec 12) guarantee the accommodation of large tensile and transverse loads on all plates.
The support side of gray and soft Nylon distributes the load on the surface of the plate and thus minimizes the weakening of the supporting construction material.
The perforations of conventional diameters and the short tilting element pa For easy mounting in tight recesses and also with insulation.
The sleeve with white flange with snap-in function enables fast and safe pre-mounting of the plug in the hole.
With scale on the traction strap (fischer DuoTec 12 ) to indicate the required length of the screw (value on the scale + 20 mm).
Suitable for:
Gypsum board
Fiber-reinforced plasterboard
Wood panels, such as prestressed wood, board fiberboard and plywood
Steel sheets
Plastic boards
Hollow concrete blocks
Also works on:
Solid materials such as concrete and wood
Minimal cavity depth at 40 mm
Vis diameter ds = 4.5 - 5.0 mm
Min. Du trou de perçage: h1 ls - tfix + 10 mm
Longueur minimale. vis ls tfix + 55mm
Longueur d'ancrage l 50 mm
Max. épaisseur des éléments fixes t fix ls - 55mm